## Why Does BBO use percent on each hand rather than matchpoints to Calculate Final Standings?

### #1

Posted 2021-July-04, 06:52

By that I mean that BBO calculates the percent standing of each hand (say beating 80% of other pairs or 20% of other pairs) and then averages all percentages to achieve a final percent standing for the game. Based on the percent standing, the final matchpoints are calculated.

In the club games and ACBL tournaments which I've played, a match point is assigned to each hand and then the average matchpoints are calculated for the round. As a result, if a person has a low board, be that 0% or 40% compared to other pairs, the result would still be 0 match points. Additionally, if a person has a high board, be that 100% or 55%, the team would get the same number of matchpoints.

For me, it is much easier to get a 0% than a 100%. Because a low board is penalized the same amount in in-person club matches and tournaments, whether it was a 0% or say a 40%, it encouraged risk taking. The teaching is - "it is only one board." With BBO, that is not the case since there is a huge difference in final standings based on a 0% vs. a 40% even though both might have been low board for that hand.

So, it appears that BBO tournaments do not follow ACBL in how hand standings/matchpoints are calculated and how final matchpoints for an event are calculated.

Just curious as to why that is. Thank you and best regards.

Mike

### #2

Posted 2021-July-04, 14:19

### #3

Posted 2021-July-04, 14:36

wikipedia said:

One common form of pairs scoring is by matchpoints. On each board, a partnership scores two matchpoints for each other partnership that scored fewer points with the same cards, and one point for each other partnership that scored the same number of points. Thus, every board is weighted equally, with the best result earning 100 percent of the matchpoints available, and the worst earning no matchpoints; the opponents receive the complement score, e.g. an 80% score for a N–S pair implies a 20% score for their E–W opponents. Colloquially, a maximum matchpoints score on a board is known as a "top", and a zero score is a "bottom". The terms "high board" and "low board" are also used.

Note 1: Using American Contract Bridge League (ACBL) methods, scoring is one point for each pair beaten, and one-half point for each pair tied.

Note 2: The rule of two matchpoints for each pair beaten is easy to apply in practice: if the board is played n times, the top result achieves 2n−2 matchpoints, the next 2n−4, down to zero. When there are several identical results, they receive the average. However, complications occur if not every board is played the same number of times, or when an "adjusted" (director-awarded) score occurs. These cases can result in non-integer matchpoint scores – see Neuberg formula.

These matchpoints are added across all the hands that a pair plays to determine the winner. Scores are usually given as percentages of a theoretical maximum: 100% would mean that the partnership achieved the best score on every single hand. In practice, a result of 60% or 65% is likely to win the tournament or come close. In a Mitchell movement (see above) the overall scores are usually compared separately for North–South pairs and for East–West pairs, so that there is one winner in each group (unless arrow-switching has been applied - see above).

### #4

Posted 2021-July-04, 18:59

For one, the number of matchpoints in itself is incomplete without the number of tables (or comparisons, usually tables - 1).

5 matchpoints in 6 tables is a shared top, 5 matchpoints in 16 tacialbles is a quite poor result.

A percentage is just normalizing the result, so 5 in 6 tables is 5/(6-1)= 1, or 100% while 5 in 16 tables is 5/(16-1)=1/3 or 33.33%.

Without percentages, you need to stipulate another parameter (number of comparisons would do, in older times I saw the average instead, as in X matchpoints on a Y average).

With percentages, only one number is needed, and gives an easy read about the quality of your game.

Note that, while BBO across all sections (at the end; scores shown while tourney is running are different for each section), if you don't do this, an inconvenient number of tables, say, a prime number like 61, leaves you with sections of different sizes, then you need to normalize the results somehow, and using percentages does that, too.

### #5

Posted 2021-July-04, 19:42

### #6

Posted 2021-July-04, 20:23

helene_t, on 2021-July-04, 19:42, said:

That is a good point, and is probably the answer in full to the OP’s question. Percentages are the same no matter how the matchpoints are counted; if you are very interested in the latter, you can easily work out how many matchpoints you achieved on a board, using whichever of the methods Helene mentioned. Just look in your history or later at the traveller, and count the pairs you beat. Give yourself one (or two, if you prefer) point for each of them. Then count the pairs you tied and give yourself one half (or one, if you prefer) point for each of them. Hey presto, now you know how many matchpoints you had on a board.

### #7

Posted 2021-July-04, 21:02

helene_t, on 2021-July-04, 19:42, said:

That's true, but the OP stated that in their club a score of 40% could receive 0 matchpoints. That's not possible regardless of whether you're using half points or percents, unless they're using a different scoring system altogether.

### #8

Posted 2021-July-04, 21:24

smerriman, on 2021-July-04, 21:02, said:

Yeah.

There may be some confusion caused by scores that are calculated across the whole field versus per-section results, and scores that don't auto-refresh when more tables complete the board, and tallys that are partially grandfathered from other players who played in the same direction before one subbed in. Also, BBO averages the percentages while most scoring software AFAIK calculates total matchpoints across the whole tally and calculates percentages at the end, iow BBO doesn't weight the boards by the number of comparisons.

### #9

Posted 2021-July-04, 21:33

msheald, on 2021-July-04, 06:52, said:

……..

Mike

So as has been explained, the percentage is just a way of repenting the number of matchpoints; for most people, seeing the percentages is more readily understandable. Say there are 11 tables. How are the matchpoints being counted — is 10 a top or is 20 a top? Do I have a top or an average board? So if you were just given the matchpoints, you would have to know both how many tables there were and how the matchpoints are being counted. It I beat 70% of the pairs in this game, I would rather see my score expressed as 70% than 7 matchpoints, although they are the same thing.

### #10

Posted 2021-July-04, 23:35

### #11

Posted 2021-July-05, 09:38

But I'm very confused as well as to where the "0 or 40 scores the same, 55 or 100 scores the same" - because at least in the ACBL, that's never been the case, except for BAM scoring. I know England does MPs-to-VPs for short-match "Swiss Pairs" events, but that's over the entire round, not each board. Please do explain, OP!

### #12

Posted 2021-July-05, 19:40